kvmwashington.blogg.se

Ensure that the required gyrocompasses are enabled 2.Įnsure that at least one position reference system is active and enabled 3.  From Joystick mode to Auto position mode. Controller mode and gain level selection 2. Press jaw, the current vessel heading becomes the heading set point and the system automatically keeps the vessel on this heading 4. Ensure that at least one position reference system in active and enabled 3.  Selecting automatic stabilization.Įnsure that the required gyrocompasses on enabled 2. On the posplot “ Pop-Up” menu click “View Control “ and select – true, vessel on relative and vessel in the posplot dialog box mode. Click “ Centre Here “ on the Posplot “ Pop-Up” menu 2.  Displaying the vessel in the view centre.  Press the jaw button in the mode button group twice. Set ROT ( Rate OfTurn ) Returning to joystick heading control.  Common Procedures available as for joystick mode plus, 1.Ĭontroller mode and gain level selection 2. Press jaw button twice within four second.Ĩ. Check that non of the status lamps for the surge, sway or jaw buttons in the modes button group are lit.Įnsure that the required gyrocompasses are enabled 3. ROT ( rate ofTurn )  Joystick mode with Automatic heading control. Joystick setting and environmental compensation 2. Select jaw and sway ( Auto heading and Auto stabilisation )  Common Procedure Available. Select jaw and surge ( Auto heading Automatic stabilisation) 4. Select Jaw ( Heading control with joystick ) 2. Enable the required position reference also position and heading information 6. Ensure that the required thruster, propeller and rudder enabled. Check if the has a switched or button to select be turn joystick and SDP thruster control. Ensure that the required sensor are enabled. Ensure that the required gyrocompasses are enabled. Rotation the joystick command the vessel to rotate. Moving the joystick left / right ( sway ) 3. Moving the joystick forward / back controls. Disable all position reference systems.ĭisable all thruster, propeller and rudders. Press the standby button in the mode twice. Returning to standby mode / manual lever. Enable the required thruster, propeller and rudder. Select the required vessel rotation point. THESE RECORDS CAN HELPTO MORE EASLY HOWTO OPERATE MENTIONED EQUIPMENT. NOTE: PLEASE READ NOTE BELOW RECORDS COMPILED BELOW CAN HELP NEW FRIENDS WHO OPERATE KONGSBERG K.POS.  Dynamic Positioning (DP) began in 1960’s  “Eureka” first DP vessel in 1961 o1000 over vessels/platform presently in serviceof 1961. Background - DP o Dynamic positioning (DP) is born in the 1960s. DP Topics  Background  Principles of a DP  Elements of a DP System  Position Reference Systems  DP Operations  Class to DP System Class. Dynamic Positioning Operator  Nautical Institute DPO certification progress paths.